•30-Pin pass through
•150 ft wireless range
•Water resistant remotes
•Units include RCA cable •& belt clip

Each wall that a RF signal must travel through reduces the signal strength by approximately 3db. 3db equates to approximately 30 Feet. Why is this important? If you are considering a wireless remote that provides a 60-foot range, then also consider that one wall will reduce the signal to a range that makes the remote relatively ineffective in and around an average size home. The iJet remote offers the greatest RF signal range of any remote made specifically for iPods that is on the market today.

• The new iJet Two-Way transmitter & receiver allows any iPod user to actually view song selections, artists and playlists from the remote LCD screen!

• The iJet Two-Way works with all bottom docking iPods (4th Gereation forward) including the new Nano and 5th Gen Video iPod.

FAQ - iJet Two-Way LCD Remote

1. I have no audio, or I can’t control my audio?

Answer: The iJet Two-Way LCD Remote has a 3.5mm audio output at the Bottom of the 30-Pin receiver. YOU MUST connect the audio line through this port in order to control audio.

2. I have installed the battery, but my iJet Two-Way LCD Remote is not powering up?

Answer: Please insure that the battery is installed correctly. When holding the remote upright the male (positive +) end of the battery should be facing down. * If installed correctly the male end will rest against the small spring in the plastic battery cap.

*Note As an additional trouble shooting step, please check to insure that the battery is not bad.

3. I can’t seem to get my iJet Two-Way LCD Remote to load list correctly.

Answer: Every so often we hear of a unit not responding, not loading correctly, or displaying “Out of Range”. If you experience this please follow these simple steps to clear the remotes microprocessor.

1. Turn your iPod on
2. Attach the 30-pin receiver to the bottom of your iPod
3. Take your remote and press the center button on the front pad (Play/Pause) and the “Artist button (middle button on the side) at the same time. Press buttons at the same time and release; do not press and hold. Timing is crucial, so you will know you have correctly initiated the ‘re-load” command when you see Loading……….
4. Step 3 may take up to five minutes to complete, depending on number of artists & playlists. Do not disturb process!
5. After process is finished press Artist button to verify that your artists have loaded correctly.

*Note. The download process can be affected by outside RF interference. You may need to attempt this process two or three times to insure entire list download.

3. Do I need to download both lists?

Answer: No. Once you download Artists or Playlists both lists will load.